Eumig M-1000 Stereo DC Power Amplifier Made by Luxman

Eumig M1000 Amplifier for sale.  This amp was built by Luxman in the pre- Alpine era. It has a switch on the back for electrostatic speakers, and it can run 2 Ohm loads with no difficulty. The amp uses a freon cooling system as seen on some Luxman amps of this era. This amp is very clean, both inside and out. Unit has been fully tested and cleaned and found to be in perfect working order. The unit is also in very good cosmetic condition.  There are just a few minor scratches on the top of the faceplate that can be seen in the attached photos.

Specifications:
Power output: 100 watts per channel into 8Ω (stereo)
Frequency response: 1Hz to 300kHz
Total harmonic distortion: 0.025%
Damping factor: 50
Signal to noise ratio: 95dB
Speaker load impedance: 4Ω to 16Ω
Dimensions: 19 x 5.2 x 14.8 inches
Weight: 38.5lbs